Clearance Between Feed Dog And The Needle Plate - Front To Back - Husqvarna VIKING E10 Service Manual

Clearance between feed dog and the needle plate – Front to Back
Check
1. Set pattern selector dial to "A". Turn stitch length dial to "4".
2. Turn hand wheel to move feed-dog forward and backward.
3. The feed dogs shall not at any point touch the needle plate in the back side or the front side.
Adjustment
1. Remove the base cover.
2. Loosen screw (a) of feed rock crank.
3. Moving feed-dog forward / backward until it is centered in the needle plate.
4. Tighten screw (a) after adjustment.
5. Attach covers.
104 72 72-26 23