Table of Contents
Advertisement
Alternatively, enter Edit mode by clicking the Settings icon on the
upper right part of the FM-QUADRO view, and clicking the Edit
Mode switch in the Appearance / Background dialog from Off to
On.
• The Edit mode dialog will be shown.
2.
Click the Continue to Edit Mode button to enable Edit Mode.
• An Edit Mode: ON notification will appear in the view.
To move any icon and its tooltip to a different position, do the steps that
follow:
1.
Click the Devices portion of the Devices | Background button
(below).
2.
Click-and-drag any of the stationary device icons or tooltips to
any needed position in the Topology view. Note that tooltips
representing mobile radios do not appear in Edit mode.
Alternatively, you can reset the Topology view to a strictly
hierarchical structure by clicking the Apply hierarchical view link
in the lower right part of the view.
If needed, you can add an aerial image to the Topology view. This allows
you to superimpose the network view over a map of the terrain on which
the network has been installed. For instructions on how to add an aerial
image as a background to the Topology view, refer to
map to the FM-QUADRO view" (page
To move an uploaded background image to a different position, do the
steps that follow:
1.
Click the Background portion of the Devices | Background
button (below).
2.
Click-and-drag the background image to any needed position in
the Topology view.
3.
Adjust the scale of the background image by clicking-and-
dragging the Adjust background scale slider.
4.
Adjust the relative transparency of the background image by
clicking-and-dragging the Adjust background transparency
slider.
When you are finished editing, click the Save changes button to save
your changes. Alternatively, click the Discard changes button to revert to
your previous configuration.
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
97).
"Adding an aerial
Page 95 of 189
Advertisement
Table of Contents
