Table of Contents
Advertisement
Figure 26. Configurator GUI (Wireless Radio dialog)
2.
Enter a defined network passphrase in the Shared Passphrase
field.
3.
Specify the country in which the unit is installed by selecting the
correct option from the Country drop-down menu.
4.
Specify the unit's operating frequency by clicking the correct
option in the Frequency (MHz) drop-down.
• You can change the frequency of each radio link in order to
minimize
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
IMPORTANT
If a shared passphrase is defined, the same
passphrase must be used for all Cisco units inthe
same network.
The shared passphrase can be composed of any
ASCII characters except the following: '`"\$=
CAUTION
Different
countries
frequently
telecommunications regulations. If the Country listing
is not set correctly, the unit may violate national
telecommunications legislation.
CAUTION
Make sure that the chosen country listing matches
the country in which the unit is installed before
changing the Frequency (MHz) value.
interference
with
have
differing
other
wireless
networks
Page 75 of 189
Advertisement
Table of Contents
