Table of Contents
Advertisement
Connect the antennas to the unit by doing the following steps:
1.
The number and types of antennas to be connected to the unit
will have been decided at the network design stage. Verify which
antenna will be connected to each QMA plug.
2.
Only remove the rubber sleeve from a QMA plug (above) if an
antenna must be connected to the plug.
Next, proceed to the steps in the following table:
3. Check the round, knurled nuts of the QMA
connectors for tightness (above). If any round
nuts are loose, tighten them by hand only.
© 2021 Cisco and/or its affiliates. All rights reserved.
Hardware installation
4. Slide a section of Nylon heat-shrinkable tubing
over each unconnected antenna cable (above).
5. Push the male QMA plug of the antenna cable
into the female QMA plug of the unit.
6. Screw the threaded sleeve of the male plug
onto the female plug. Tighten the connection by
hand only.
7. Slide the lengths of Nylon heat-shrinkable
tubing over the tightened QMA connectors.
8. Use a heat gun to shrink the tubing onto the
connectors.
Page 50 of 189
Advertisement
Table of Contents
