Table of Contents
Advertisement
7.7.7. Resetting the unit to factory defaults
The reset factory default window contains controls that allow you
to restore the Cisco FM4200 Fiber to its default factory settings (in other
words, to do a 'hard reset').
IMPORTANT
Doing a hard reset will revert all unit configuration settings,
including the unit's IP address and administrator password, to
factory defaults.
If you want to reboot the unit instead, refer to
unit" (page 154)
To reset the unit to its factory defaults, do the following steps:
1.
Click the -reset factory defaults link under MANAGEMENT
SETTINGS in the left-hand settings menu.
• The unit reset dialog will be shown
Figure 64. Configurator GUI (unit reset dialog)
2.
Reset the unit to its factory defaults by clicking the YES link.
Alternatively, abort the factory reset by clicking the NO link.
• If the YES link was clicked, the unit will do a factory reset,
and will reboot.
3.
If you have previously saved a device configuration file for the
unit, you can restore the saved configuration settings to the unit
as shown in
Rebooting the unit
The reboot window contains controls that allow you to reboot the Cisco
FM4200 Fiber (in other words, to re-start the unit's operating system).
To reboot the unit, do the following steps:
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
below.
CAUTION
Do not do a hard reset unless the unit needs
to
be
reconfigured
configuration as a starting point.
A hard reset will reset the unit's IP address
and
administrator
disconnect the unit from the network.
"Saving and restoring the unit settings" (page
"Rebooting the
(Figure 64 (page
154)).
using
its
factory
password,
and
will
152).
Page 154 of 189
Advertisement
Table of Contents
