Table of Contents
Advertisement
4.
If needed, enter the host name of a chosen secondary NTP
server in the Secondary NTP server (optional): field.
5.
Select the time zone in which the unit is installed by clicking
the Select Timezone: drop-down menu and clicking the correct
time zone option.
6.
Save the NTP settings by clicking the Save button. Alternatively,
clear the settings by clicking the Reset button.
7.6.10. L2TP configuration
IMPORTANT
The L2TP configuration option is only available if the Cisco
FM4200 Fiber is set to Mesh Point mode or Mesh End mode.
If the unit is set to Bridge mode, the -l2tp configuration menu
option will not be available.
The L2TP feature must be enabled using a software plug-in
(Cisco part number FM-L2TP). Contact your Cisco
Networks representative for details.
Layer 2 Tunneling Protocol (L2TP) functionality allows Cisco radio
transceivers to support integration with virtual private networks (VPNs).
Cisco hardware devices are shipped from the factory with L2TP
functionality disabled. To change the unit's L2TP settings, do the following
steps:
1.
Click the -l2tp configuration link under ADVANCED SETTINGS
in the left-hand settings menu.
Figure 49. Configurator GUI (L2TP Configuration dialog)
• The L2TP Configuration dialog will be shown
(page
2.
To enable L2TP functionality for the unit, check the L2TP check-
box.
• The L2TP configuration settings window will be shown.
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
129)).
(Figure 49
Page 129 of 189
Advertisement
Table of Contents
