Table of Contents
Advertisement
E. FRONT PANEL AND MAIN DOOR ASSEMBLIES
To Replace Main Door Switch
1. Discontinue electrical power to the dryer.
2. Open main door.
3. Remove the Phillips head screws holding the top or main
control panel.
4. Disconnect wiring connecting switch to computer board/
harness.
5. Disassemble door switch from bracket by removing two
Phillips screws securing the switch to the panel.
6. Reverse this procedure for installing new door switch.
7. Reestablish electrical power to the dryer.
IMPORTANT: Under no circumstances should the
door switch be disabled.
To Install New Main Door Glass
1. Remove main door assembly from dryer.
2. Lay main door on flat surface with the rear of the door facing up.
3. Drill all outer permiter pop rivets and remove door handle.
4. Remove glass and clean all old sealant off main door. This area must be completely cleaned for correct bonding.
5. Apply a narrow bead of silicone (ADC P/N 170730) all around main door area where glass will rest.
6. Install glass onto door adhesive and slightly press glass in place.
IMPORTANT: Do not press hard or silicone thickness between the glass and door, the bead of
silicone will be reduced, resulting in poor bonding.
7. The door assembly should now be put in an area where it will not be disturbed for at least 24 hours. Depending
on the conditions, the curing time of this adhesive is 24 to 36 hours.
8. Pop rivet the inner door to the outer door and reattach the door handle.
9. After 24-hour curing period, install main door on dryer by reversing Step #1-2.
20
American Dryer Corp.
450319 - 1
Advertisement
Table of Contents
