1. Manuals
  2. Brands
  3. ADC Manuals
  4. Dryer
  5. ML-82
  6. Installation manual

ADC ML-82 Installation Manual

Gas - dsi /steam models
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
ML-82
(Gas - DSI /Steam Models)
Installation Manual
American Dryer Corporation
041700WM/tcosta
ADC Part No. 113143

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ML-82 and is the answer not in the manual?

Questions and answers

Related Manuals for ADC ML-82

Summary of Contents for ADC ML-82

  • Page 1 ML-82 (Gas - DSI /Steam Models) Installation Manual American Dryer Corporation 041700WM/tcosta ADC Part No. 113143...
  • Page 2 The following “FOR YOUR SAFETY” caution must be posted near the dryer in a prominent location. We have tried to make this manual as complete as possible and hope you will find it useful. ADC reserves the right to make changes from time to time, without notice or obligation, in prices, specifications, colors, and material, and to change or discontinue models.
  • Page 3 IMPORTANT CAUTION CAUTION WARNING...

  • Page 4: For Your Safety

    FOR YOUR SAFETY WARNING WARNING IMPORTANT...
  • Page 5 Table of Contents...
  • Page 7 SECTION I IMPORTANT INFORMATION must be...
  • Page 8 must be must never be DO NOT DO NOT...
  • Page 9 DO NOT DO NOT...

  • Page 10: Specifications/Component Identification

    SECTION II SPECIFICATIONS/COMPONENT IDENTIFICATION 37" 94 cm ASKET UMBLER IAMETER 36" 91.5 cm ASKET UMBLER EPTH 1/2 HP .373 kw ASKET UMBLER OTOR 3 HP 2.238 kw LOWER OTOR 21-1/2" 54.61 cm PENING IAMETER 22.4 cu. ft. .634 cu.m. ASKET UMBLER OLUME 20’/40’’...

  • Page 11: Specifications

    Specifications ML-82 (Gas and Steam ONLY)

  • Page 14: Installation Procedures

    SECTION III INSTALLATION PROCEDURES must be should be...
  • Page 15 must be 012999JEV-GS/cj P/N: 114092...
  • Page 16 must be...
  • Page 17 must...
  • Page 18 EXAMPLE: must be MUST BE...
  • Page 19 should not exceed must be must be DO NOT...
  • Page 20 THE DUCT SIZE MUST NOT BE REDUCED ANYWHERE DOWN STREAM OF THE DRYER should not exceed...
  • Page 21 should be must be must be DO NOT should be...
  • Page 22 should be should not exceed must be must be DO NOT...
  • Page 24 DO NOT use aluminum wire which could cause a fire hazard. must be...
  • Page 25 M LG-82 (Gas) M LS-82 (Steam) LECTRIC ERVICE PECIFICATIONS PER DRYER IMPORTANT: 208 VAC and 240 VAC ARE NOT THE SAME. When ordering, specify exact voltage. NOTE: A. Fuse ratings are dual-element, time-delay, current limiting, class RK1 or RK5 ONLY. B.
  • Page 26 MUST BE...
  • Page 27 DO NOT operate dryer must be...

  • Page 28: Type Of Gas

    YPE OF Natural Liquid Propane 8.7 mb 26.1 mb Manifold Pressure* 3.5 inches W.C. 10.5 inches W.C. 14.92 - 29.9 mb 26.1 mb Inline Pressure 6.0 - 12.0 inches W.C. 10.5 inches W.C. Shaded areas are stated in metric equivalents * Measured at gas valve pressure tap when the gas valve is on.
  • Page 29 must be must be must be...
  • Page 31 must be must be Operating Steam Pressure Maximum 125 psig 861.84 kPa Minimum 100 psig* 689.47 kPa Heat Input (Normal Load) 7 Bhp Consumption (Approximate) 239 lbs/hr 108.41 kg/hr Shaded areas are stated in metric equivalents * Minimum operating pressure for optimum results.
  • Page 32 must be...

  • Page 33: Compressed Air Supply

    Compressed Air Supply Air Pressure Normal 80 PSI 5.51 bars Minimum Supply 70 PSI 4.82 bars Maximum Supply 90 PSI 6.20 bars Shaded areas are stated in metric equivalents...
  • Page 35 THE SUPPLY VOLTAGE MUST MATCH THE ELECTRIC SERVICE EXACTLY...
  • Page 36 must be must be...
  • Page 37 should not be must be must be...

  • Page 38: Gas Models

    GAS MODELS STEAM MODELS...

  • Page 39: Service/Parts Information

    SECTION IV SERVICE/PARTS INFORMATION...

  • Page 40: Warranty Information

    SECTION V WARRANTY INFORMATION...
  • Page 41 must be Damage claims are the responsibility of the shipper.

  • Page 42: Routine Maintenance

    SECTION VI ROUTINE MAINTENANCE SUGGESTED CLEANING SCHEDULE EVERY THIRD or FOURTH LOAD WEEKLY...
  • Page 43 STEAM DRYERS 90 DAYS EVERY 6 MONTHS DO NOT 7 DAYS AFTER INSTALLATION and EVERY 6 MONTHS THEREAFTER...

  • Page 45: Procedure For Functional Check Of Replacement Components

    SECTION VII PROCEDURE FOR FUNCTIONAL CHECK OF REPLACEMENT COMPONENTS...
  • Page 47 must read normal operation...
  • Page 48 must shut off must lockout must proceed...

  • Page 49: Section Viii

    SECTION VIII DATA LABEL LOCATION/INFORMATION...

  • Page 51: Burner And Lint (Tumbler) Chamber Manual Reset Hi-Limit Instructions

    FOR PHASE 6 MODELS (GAS MODELS ONLY) IMPORTANT This dryer is equipped with a burner hi- limit and tumbler/lint chamber hi-limit ther- mostat which must be reset manually. WARNING: Discontinue power to dryer before attempting to reset hi-limit. ADC P/N: 114093...
  • Page 52 MANUAL RESET HI-LIMIT INSTRUCTIONS FOR PHASE 6 MODELS (STEAM MODELS ONLY) IMPORTANT This dryer is equipped with a lint chamber hi-limit thermostat which must be reset manually. WARNING: Discontinue power to dryer before attempting to reset hi-limit. ADC P/N: 114501...
  • Page 53 ADC 113143 1 -05/01/00-25 2 -05/09/00-25 3 -05/26/00-50...

Table of Contents