Table of Contents
Advertisement
EN
OPERATION
3.
3.1 Machine start-up
Pict. 1
stand-by
• Turn the button G.The LED positioned below the
is on
STAND-BY
mode, the LED will turn red).
The display
M
will read
Should the machines be equipped with the WRAS certifi ed Break Tank, the tank fi lling phase is extended.
The display will read HEATING, till wash-tank and boiler will reach the set temperatures.
filling water
page 26
3.1.1 Start-up
• Check if the pump suction fi lter is properly inserted in its seat in the wash-tank
bottom (see pict. 1).
• This fi lter must be cleaned every 20 wash-cycles or whenever necessary.
•
DO NOT use the appliance without the fi lter.
• Insert the overfl ow pipe in its seat inside the pump suction fi lter (see pict. 1).
• Put the surface fi lters in place (see pict. 1).
• Shut the dishwasher door.
• Turn the water valve "open".
• Turn the main power switch ON.
• The display
• The machine is on STAND-BY. In the
appear.
FILLING
WATER.
heating
2.
CONTROL PANEL AND RELATIVE SYMBOLS
A)
Cycle light indicator
B)
Full tank indicator
C)
Button, not available
D)
Heating tank indicator
E)
Heating boiler indicator
F)
START key to start up cycle / Programming key
G)
Switching ON / OFF / Programming key
H)
Info (temperature / software review / key factory)
I)
Regeneration key (optional) / Decrease
L)
Drain Pump key (optional) / Increase
M)
Display
M
will show, for a few seconds, the installed software version code.
G
control, will light (green color) at the machine's start (when the machine
M
display, the message
STAND-BY
will
Advertisement
Table of Contents
