SECTION 2 - INSTALLATION IMPORTANT A. INSTALLATION OPTIONS & KIT AVAILABILITY Before proceeding with the electrical connection, check that If the installation will require two or three ovens to be stacked, the electrical supply matches the ovens requirements. Refer you must use the separately-available Stacking Kit (P/N to the serial plate and to the Electrical Specifications table T2114STACK).
SECTION 3 - OPERATION A. LOCATION FUNCTION are u CONTROLS The Preset Menu keys (1-5) Power On/Off (I/O) switch MenuSelect controller ® Conveyor reversing switch The display CAUTION Do not operate the conveyor reversing switch while the conveyor is in motion. The ready light B.
Page 6
C. OPERATION Perform the procedure in Section E, , on Page 5. At least one menu selection MUST be programmed before the oven can be operated. Perform the procedure in Section E, , BUT press instead (in Steps 3 and 8). Instead of permanently overwriting the menu selection, the new set temperature and cook time settings are only temporary.
Page 7
E. PROGRAMMING PRESET MENU SELECTIONS IMPORTANT Adding a menu program to the oven will overwrite an existing program. DO NOT enter a new menu program over an existing program that you wish to keep! CHOOSE A MENU Press and hold (or any other preset menu key) until appears in the display.
Page 8
F. COOKING TIME AND TEMPERATURE G. DRAFT CURTAIN ADJUSTMENT GUIDELINES IMPORTANT The cooking times and temperatures shown below are recommendations only. You should always test each food product to determine correct time and temperature settings. SET TEMPERATURE COOK WARNING PRODUCT upper lower TIME...
Page 9
H. DAILY CLEANING WARNING WHEN CLEANING THE OVEN: NEVER USE PRESSURIZED WATER. NEVER USE A CLEANING SOLUTION OTHER THAN SOAP AND WATER ON PORTIONS OF THE OVEN IMPORTANT THAT COME INTO CONTACT WITH FOOD If the end trays are removed for cleaning, they must be PRODUCTS.
Page 10
I. DISPLAY MESSAGES AND ERROR CODES DISPLAY SHOWS PROBLEM ACTION Set Temperatures or Cook Time Outside of Allowed Programming Preset Menu Selections Range Heating Element turned off Programming Preset Menu Selections - - - - No Menu Selection Chosen E-00 Preset Menu Program Lost E-01 High Ambient Condition...
SECTION 4 - ELECTRICAL WIRING DIAGRAMS Wiring Diagram, Model TCO21140035, 230V, 1 Phase TOP HEATER CC FUSES (2) 5.0A/600V FILTER BOTTOM HEATER CONTACTOR TFRMR TFRMR MOTOR PICKUP ASSY 230Vp 230Vp TSTAT 115Vs 12Vs N.C. FUSE 0.25A TSTAT FUSE 0.5A N.O. SSR 1 SSR 2 BLACK...
Page 12
SSR 1 SSR 2 TOP HEATER 2500W SSR 2 SSR 1 Wiring Diagram BOTTOM HEATER 2500W Ref. P/N 38710, Rev. E is a registered trademark of CTX, A Middleby Company. All rights reserved. Middleby Corp 24-Hour Service Hotline 1-800-238-8444 www.middleby.com...
Need help?
Do you have a question about the CTX Mighty Chef TCO2114 and is the answer not in the manual?
Questions and answers