Nu-Vu SMOKE6 Manual page 6

Electrical Connections
F. Install the water supply (refer to WATER SUPPLY CONNECTION on the following page).
G. The installing technician or electrician should complete the electrical connections by removing the
Outside Top of the unit, this panel is held in place with two screws located on the top of the unit.
Connect the unit to the available power supply either through an attached cord and receptacle or
through direct wiring by following these steps:
1.Take note of the labeling on the Power Terminal Block (Line 1, Line 2, Line 3, ).
2.Carefully identify the power source leads and attach them to the appropriate terminal
connections. Make sure all connections are clean and tight.
3.Properly ground the unit BEFORE USE by attaching a grounding wire to the Ground Lug or
Clamp provided next to the Power Terminal Block.
4.Allow enough slack in the wiring to allow for equipment to be moved about during installation
and any future servicing.
H. Check the voltage at the terminals on the Power Terminal Block with a voltmeter and compare the
values with the label listings on the side of the Oven. If the values match the unit is ready for its
INITIAL START–UP. If the readings DO NOT coincide you must call the NUVU Service
Department for instructions on changing the voltage and/or the phase.
I. Carefully position the Outside Top on the unit but do not press it into place. Position the unit in its
final operating location and refer to the appropriate INITIAL START–UP PROCEDURE for your
Smoker.
IMPORTANT: FAILURE TO FOLLOW THESE INSTRUCTIONS, FAULTY INSTALLATION OR
IMPROPER USE MAY CAUSE SEVERE EQUIPMENT DAMAGE OR PERSONAL INJURY, AND MAY
ALSO VOID ALL OR PART
This page was created using BCL ALLPDF Converter trial software.
To purchase, go to http://store.bcltechnologies.com/productcart/pc/instPrd.asp?idproduct=1
OF YOUR NUVU EQUIPMENT WARRANTY!!!
6