Receipt And Installation - Nu-Vu SMOKE6 Manual

RECEIPT AND INSTALLATION

RECEIPT:
It is essential to inspect the unit immediately when it arrives. NUVU has placed instructions on the packaging
to help avoid damage in transit. However, negligent handling can produce hidden damage. These steps should
be carefully followed:
A. Inspect the entire perimeter of the package for damage or punctures to the packing material. This
may indicate damage to the unit inside. Call any and all packing damage to the attention of the
delivery person.
B. If any packing damage is found uncrate the unit immediately in the presence of the delivery person
to determine if the unit is damaged. If any damage is found indicate the type and amount of
damage on the shipping documents and notify NUVU at 1-800-338-9886 immediately after filing a
freight claim.
C. Uncrate the unit carefully and check the entire unit (top, front, back and both sides) for any visible or
hidden damage.
D. Remove the unit from the shipping pallet and inspect the bottom for any damage.
E. If any damage is noted after the driver leaves immediately contact the freight company and NUVU.
F. Check each Oven Door. Make sure the Door closes completely, and that the Door Gasket seals
firmly. If the Gasket does not seal correctly please contact the NUVU Service Department for
instructions and assistance in any required adjustments.
INSTALLATION:
A. Check to determine that the power source is the same voltage and phase as that indicated on the label
on the side of the unit.
B. If you have received an SMOKE6 you should attach the included Appliance Legs to the bottom of
the unit. Each Leg stud screws into a threaded hole in each corner of the base.
C. Position the unit where it is to be operated and adjust the Appliance Legs of the ES–6 so the unit
stands level and solid. If you have an SMOKE13 you may need to use metal shims under the
Casters to level the unit.
D. Make sure the GREASE PAN is installed inside the bottom of the unit. This PAN will catch most of
the drippings from your product as it is processed, making clean-up that much easier.
E. Make sure the DRIP TROUGH is installed beneath the unit. This PAN will catch the liquid that
drains out the front of the unit when the door is opened
F. Carefully set all Controls and Switches to their OFF positions.
This page was created using BCL ALLPDF Converter trial software.
To purchase, go to http://store.bcltechnologies.com/productcart/pc/instPrd.asp?idproduct=1
5