Table of Contents
Advertisement
4. Put back the rear top cover you lifted in step 2.
Align the pin at the side of the rear top cover with the slots on the chassis' edge, and
push the rear top cover back in position.
Put back and fasten the screw on the back of the XCubeNAS.
5. Remove memory module.
Follow step 1 and 2 above to shut down your XCubeNAS, and disconnect the cables,
and then remove the rear top cover.
Disengage the memory retaining clips by pushing them outwards, and the module
will pop out of the slot.
Follow step 4 above to put back the top cover.
The following table is the suggested installation combination for memory.
Table 3-2
Slot #1
4GB
4GB
8GB
8GB
16GB
16GB
22
© Copyright 2019 QSAN Technology, Inc. All Rights Reserved.
The Suggested Installation Combination for Memory.
Pair #1
Slot #3
4GB
4GB
8GB
8GB
16GB
16GB
Pair #2
Slot #2
Slot #4
-
-
4GB
4GB
-
-
8GB
8GB
-
-
16GB
16GB
Total Memory
8GB (Default)
16GB
16GB
32GB
32GB
64GB
Advertisement
Table of Contents
