Dispensing Hot Water; Preparing Milk Froth; Maintenance And Daily Cleaning - Bosch TES 552 Series Instruction Manual

Dispensing hot water

¡
Risk of burns
The milk frother (6) gets very hot. Hold the
milk frother (6) by the plastic part only.
The appliance must be ready for use with
the cleaned milk frother attached.
1. Place the pre-warmed cup or glass
under the outlet of the milk frother (6).
2. Pull the milk frother (6) to open it. The
appliance heats up. Hot water runs out
of the milk frother outlet (6) for about
40 seconds.
3. Stop the process by pushing in the milk
frother (6).

Preparing milk froth

¡
Risk of burns
The milk frother (6) gets very hot. Hold the
milk frother (6) by the plastic part only.
Tip: You can foam the milk first and then
dispense coffee, or foam the milk separately
and pour it onto the coffee.
The appliance must be ready for use with
the cleaned milk frother attached.
h
1. Press the button (11).
h
The button (11) flashes and the
appliance now heats up for approx.
20 seconds. The display then shows
Pull milk frother
2. Immerse the milk frother so that it
reaches the bottom of a cup or glass
that is one-third filled with milk.
3. Pull the milk frother (6) to open it.
¡
Risk of scalding
Splashes of milk can scald. Do not touch
the outlet (6a) or aim it at anyone.
4. Close milk frother (6) by pushing it in.
.
Tip: For optimal milk froth quality, use cold
milk with a fat content of at least 1.5 % if
possible.
Important: Dried milk residue is difficult
to remove, so the milk frother (6) must be
cleaned with lukewarm water immediately
after use and rinse using the
programme.
system
Maintenance and
daily cleaning
¡
Risk of electric shock
Unplug the appliance before cleaning it.
Never immerse the appliance in water.
Do not use a steam cleaner.
● Wipe the outside of the appliance with a
soft, damp cloth.
● Do not use abrasive cloths or cleaning
agents.
● Always remove any limescale, coffee,
milk or descaling fluid residue immedi-
ately. Such residue can cause corrosion.
● New sponge cloths may contain salts.
Salts can cause rust film on stainless
steel and must therefore be washed out
thoroughly before use.
● Pull the drip tray (8c) with the coffee
grounds container (8b) forward and out.
Remove the panel (8a) and the grate
(8d). Empty and clean the drip tray and
coffee grounds container.
en
Rinse milk
33