Assembly - Shop-Vac SC14 Series User Manual

CASTER SYSTEM
Follow the instructions for the caster system that came with your vacuum.
PLASTIC TANK WITH REAR CASTER DOLLY
You will find four casters, two caster feet, one dolly and four screws with your wet/dry vacuum.
Assemble as follows:
1. With cord disconnected from receptacle and tank cover removed, turn
tank upside down so that the bottom is facing up.
2. Take rear caster dolly and place into slots (on rear of tank, opposite of
inlet) and secure with screws provided.
3. If flat washers are included in hardware package place flat washer over stem of
caster before installing casters into feet and dolly. NOTE: Flat washers are not
required with all units.
4. Insert casters into bottom of rear caster dolly by placing stem of caster into holes
provided. Apply pressure and twisting motion until casters snap into place.
5. With tank drain facing you, take caster foot marked with the letter A and
place in slot on left side of tank also marked with the letter A and secure
with screw provided.
6. Take caster foot marked with the letter B and place in slot on right side of
tank also marked with the letter B and secure with screw provided.
7. Insert casters into feet by placing stem of caster into holes provided. Apply
pressure and twisting motion until casters snap into place. Return tank to
upright position.
METAL TANK WITH PLASTIC DOLLY AND REAR WHEELS
You will find two casters, two large rear wheels, one axle, tool rack, two cap nuts and one screw
pack (containing four screws) with your wet/dry vacuum. Assemble as follows:
1. Make sure the cord is disconnected from the receptacle then remove the tank cover.
2. Turn tank upside down so the bottom is facing up.
3. Place axle upright on a hard surface and hammer on one cap nut.
4. Place one wheel on axle and slide down to cap nut. Be sure flat side of wheel hub is
facing outward.

ASSEMBLY

Screw
Caster
Foot
Screw
Caster
Caster
Caster
Foot
PAGE 5
Foot