Shop-Vac SC14 Series User Manual page 6

5. Slide axle through holes provided in tool rack.
6. Slide remaining wheel onto axle and hammer on second cap nut.
7. Install tool rack assembly onto dolly (already installed on tank) by placing large slot
in tool rack over rim on back of dolly. Push tool rack onto dolly until the bottom of tool
rack is flush with bottom of dolly. NOTE: It is normal for tool rack to fit tightly onto
dolly.
8. Secure with four screws provided.
9. If plastic flat washers are included in hardware package, place one flat washer
over stem of each caster. NOTE: Flat washers are not required with all units.
10. Insert casters into front of dolly by placing stem of casters into holes provided.
Apply pressure and twisting motion until casters snap into place.
11. Return tank to upright position.
CARRIAGE HANDLE FOR METAL TANK
If your vacuum came with a carriage handle, follow these instructions. The carriage handle does not come
standard with all models. You will find one carriage handle and a handle pack containing two side tank
handles, four handle supports and eight screws. Assemble as follows:
1. Take two handle supports and two 1" screws. Place screws through the hole
provided in center of each support.
2. Position the tank, in the upright position, with the inlet facing you. Put the support
assemblies inside the tank, then place the screws through the holes provided on
left side of the tank. Make sure the plastic portion is located inside the tank. Turn
the supports until the back of the supports fit flush against the inside curve of the
tank.
PAGE 6
ASSEMBLY (CONT'D.)