Installation - Westinghouse WRCG914BC Installation & User Manual

INSTALLATION

Pre-installation
Before installing the cooker hood, peel off any protective
coating.
Location
The hood is to be mounted on the wall. When installed,
the hood must be not less than 60cm above electric
burners or 65cm above gas or mixed-fuel burners.
DISTANCE FROM HOOD BASE TO TOP OF HOB
HOB TYPE
Gas
Electric
* If the instructions of the hob specify a greater distance
than the minimum above, then that shall be the minimum
height for installation.
130
232
306
52
Min 650mm
Max 800mm
Gas
8
INSTALLATION
MINIMUM* MAXIMUM
650mm 800mm
600mm 800mm
WRCG930SB
250
Telescopic flue cover
235 mounting bracket
Lower flue cover
mounting bracket
250
Range hood
mounting points
190 Anti tilt fixing point
Highest point
Min 600mm
of hob
Max 800mm
Electric
Installation
1. Using a spirit level mark a vertical centre line on
the wall where the hood is to be positioned, and a
horizontal line at the hood base position. (See Fig. 4,
or 5 for relevant model.
NOTE : The height of the underside of the hood body
must be a minimum of 600mm* to a maximum height of
800mm .
*If the instructions of the hob specify a greater distance
than the minimum above, then that shall be the minimum
height for installation.
2. Mark the location for the flue cover wall mounting
brackets and rangehood mounting points and anti-tilt
fixing points above the hood base using the hood
base as a reference point
W ARNING
WARNING
Failure to install the screws or fixing device in accordance
with these instructions may result in electrical hazards.
WRCG940SB/WRCG914BC
250
130
235
290
250
364
185
33
Min 650mm Min 600mm
Max 800mm Max 800mm
Gas
Telescopic flue cover
mounting bracket
Lower flue cover
mounting bracket
Range hood
mounting points
Anti tilt fixing point
Highest point
of hob
Electric