Products must be used, installed and operated in accordance with this manual. You may not be able to claim on the Westinghouse manufacturer’s warranty in the event that your product fault is due to failure to adhere this manual.
This manual explains the proper use of your new WARNING WARNING Westinghouse canopy rangehood. Please read this manual carefully before using the product. This manual These warnings have been provided in the interest of should be kept in a safe place for handy reference. This safety.
Page 4
IMPORTANT SAFETY INSTRUCTIONS (CONTINUED) Electrical connection Check that the mains voltage matches with the voltage on the data plate inside the canopy rangehood. Check that the installation complies with standards of local building, gas and electrical authorities. Before connecting to the mains supply ensure that the mains voltage corresponds to the voltage on the rating plate inside the cooker hood.
・ Fixings required to attach flue cover ・ Lights: 2 x 4 watt, 240 V LED (for WRCG930SB & WRCG940SB) mounting brackets ・ Lights: 2 x 3.5 watt, 240 V LED (for WRCG914BC) ・ Worm drive clamps, duct tape or cable ties ・ Ducting accessories...
W ARNING WARNING Failure to install the screws or fixing device in accordance with these instructions may result in electrical hazards. WRCG930SB WRCG940SB/WRCG914BC Telescopic flue cover Telescopic flue cover mounting bracket mounting bracket Lower flue cover Lower flue cover...
Page 9
INSTALLATION Install flue cover wall mounting brackets with Hang the body hood on the mounting screws then suitable fixings. Install suitable screws for rangehood secure at the anti-tilt locations as indicated in Fig 9 mounting points (to support a total weight of 30kg) to the wall as marked (Fig.
Page 10
INSTALLATION Insert power cord to power outlet Insure locking tab of lower flue cover to be bent before installing covers Fig. 13 Fig. 11 Fix glass canopy 10. Locate lower flue cover tab Important: Rubber washer to be assembled against glass Fig.
Page 11
INSTALLATION Slide telescopic flue cover to upper position and fix 13. Replace filter with screws provided Fig. 17 Fig. 15 12. Remove polystyrene packaging foam behind the fan motor. Fig. 16 INSTALLATION...
Page 12
INSTALLATION Depending on the preferred installation/ducting mode, follow step 14a or 14b below. Recirculating mode (Fig. 18). Using the centre line, 14a. secure the recirculating T-piece to the wall with suitable screws/fixings (optional kit AR610RK). Install flexible pipe between T-piece and reducer. Use cable ties or suitable duct tapeto secure flexible pipe to T-piece and reducer (Fig.
USING YOUR RANGEHOOD CARE & MAINTENENCE • Best results are obtained by using a low speed for normal conditions and a high speed when odours are WARNING CAUTION concentrated. External surfaces are susceptible to scratches and • Turn the hood on for a few minutes before you start abrasions, so please follow the cleaning instructions cooking.
TROUBLESHOOTING GUIDE PROBLEM WRCG930SB Check that the hood is connected to an electrical supply The cooker hood will not start Check that a fan speed has been selected Check that the fan speed is set high enough for the task The grease filters are clean The kitchen is adequately vented to allow the entry of fresh air Max absorbed power...
(c) ‘ASC’ means Electrolux’s authorised serviced centres; the Appliance; (d) ‘Westinghouse’ is the brand controlled by Electrolux Home Products In addition, Electrolux is not liable under this warranty if: Pty Ltd of 163 O’Riordan Street, Mascot NSW 2020, ABN 51 004...
Need help?
Do you have a question about the WRCG914BC and is the answer not in the manual?
Questions and answers