Led Indicators; Audible Alarm; Single Ups Operation; Turn On The Ups With Utility Power Supply (To Line Mode) - Ametek Surgex UPS-17602-52R User Manual

_________________________________________________________________

3-3. LED Indicators

3-4. Audible Alarm

UPS status
Bypass mode
Battery / Battery-test mode (normal battery voltage)
Battery / Battery-test mode (low battery voltage)
Fault
Warnings (except overload)
Overload

3-5. Single UPS Operation

3-5-1. Turn on the UPS with utility power supply (to Line mode)

1) Make sure mains input and battery are connected and that the battery pack breaker is in the "ON" position.
Set the external mains input breaker to the "ON" position. The fan will now be running and the UPS will
supply power to the loads via bypass. The UPS is operating in Bypass mode.
NOTE: When the UPS is in Bypass mode, the output voltage comes directly from the utility and the load
is not protected by the UPS. To protect the load the UPS must be turned on to Line mode.
2) With the LCD on home page, press the "ON/ENTER" button. The LCD will show a prompt page of "Turn
On". Move the arrow to "Yes" using the up or down button and then press "ON/ENTER". The UPS will
start up and beep once. You could also enter the "control menu" to select the instruction "Turn On" to
startup the UPS. Please refer to the section "LCD operation".
3) A few seconds later the UPS will enter Line mode and "Line mode" will be displayed on the LCD.
NOTE: In line mode, if the utility power is abnormal, the UPS will transfer to Battery mode without
interruption.
fdfefd fd
© 2019 AMETEK Electronic Systems Protection | Technical Support: 1-800-645-9721 | surgex.com
Buzzer status
Beeping once every 2 minutes
Beeping once every 4 seconds
Beeping once every second
Beeping continuously
Beeping once every second
Beeping twice every second
User Manual
Mute Control
Yes
Yes
Yes
Yes
No
No
18