1. Manuals
  2. Brands
  3. Baicells Manuals
  4. Network Hardware
  5. Nova-436Q
  6. Quick installation manual

Baicells Nova-436Q Quick Installation Manual

5g nr base station
Hide thumbs Also See for Nova-436Q:
1
2
3
4
5
6
7
8

Advertisement

Table of Contents

5G NR Base Station
Quick Installation Guide

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Nova-436Q and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Baicells Nova-436Q

Summary of Contents for Baicells Nova-436Q

  • Page 1 5G NR Base Station Quick Installation Guide...
  • Page 2 1. Appearance...

  • Page 3: Installation Material

    Interface Description Power interface: The base station supports AC or DC power supply. AC: 90VAC ~ 264VAC, nominal voltage is 110/220VAC DC: -40VDC ~ -57VDC, nominal voltage is -48VDC RJ-45 interface, used for debug or data backhaul. Optical interface, connect to external transmission network, used for data backhaul.

  • Page 4: Installation Tool

    Item Description It is suggested that the diameter of the cable is 7±1mm. Ethernet cable Outdoor CAT6, shorter than 100 meters (~109 yards) Ground cable If the length of lead is more than 10 meters, a ground cable with 16mm² cross section should be used. If the length of lead is less than 10 meters, a ground cable with 10mm²...
  • Page 5 Install GPS Antenna Read the following GPS antenna installation requirements before installing it on the base station.  No major blocking from buildings in the vicinity. Make sure the space atop is at least 45 degrees unblocked by any buildings. ...

  • Page 6: Pole Mounting

    It is strictly prohibited to pull or drag the integrated antenna cables during the construction process to avoid damage to the antennas or accidental dropping of the gNB. Pole Mounting Check to ensure the diameter of the pole is in the range of 1.6 inches to 3.9 inches (40mm to 100mm).

  • Page 7: Wall Mounting

    Wall Mounting Ensure that the wall can bear at least four times the weight of the base station. Before installation, remove the screw bolts from the pre-installed bracket, leaving only the wall- mounting bracket part. Following steps introduce how to fix the pre-assembled base station on a wall. ATTENTION: You can adjust the gNB to a proper angle by adjusting the screw on the side of the bracket.
  • Page 8 To ensure the safety of the GPS antenna, it is necessary to connect the GPS antenna through a surge arrester. Screw the adaptor onto the gNB's GPS port. Screw the surge arrester onto the adapter. First, place the larger and then the smaller cold shrink...

This manual is also suitable for:

Nova 436q

Table of Contents