ChimneyFree 18IRM9984-C325 Manual page 5

OPERATION INSTRUCTIONS
FUNCTION
POWER
FLAME
HEATER
TIMER
FLAME SPEED
COOL DOWN CYCLE
A5441
ICON DESCRIPTION
The power button supplies power to all of the fireplace
functions. The power button will put the insert in a
standby mode. This will turn off all functions at once, but
will hold the settings in the memory. By pressing the Power
button again, the unit will turn on with the retained settings.
With the power on, press and hold the Power button on
the control panel for 10 seconds to disable or re-enable the
heater function. Once disabled or re-enabled, the ember bed
lights will flash multiple times.
There are 5 brightness levels that can be selected, as well as
an OFF (00) setting.
Settings F5- F1 decrease in brightness.
The fireplace contains three infrared quartz heating
elements.
The up and down buttons "
temperature setting.
The thermostat setting range is 62°F - 82°F (17°C - 27°C) or
continuously ON. To set flame effect so that it works without
heat, press the heater button until the display shows "00".
The thermostat is adjustable by 2°F or 1°C increments.
To change between °F and °C, press and hold the TIMER
button on the control panel for 3 seconds.
Pressing the timer button will cycle through the timer
settings: 30 minutes, 1 Hour, 2H, 3H, 4H, 5H, 6H, 7H, 8H,
9H and off (00).
The flame speed is only adjustable from the remote control.
Setting S1 is slowest, ranging up to setting S5 which is the
fastest.
Before the fireplace powers off, the fan will continue to run
for a period of time to cool down the internal parts.
5
" will increase / decrease
www.tsicustomerservice.com