Basic Operations; Turning The Display On Or Off; Turning Off The Display By Quickoff; Initial Setup - BenQ RP552H User Manual

Basic operations

Turning the display on or off

1. Be sure to following the instruction of
2. Before turning on the display, make sure the Power switch is set to ON (I). The
system will enter standby mode.
RP552/RP552H
The display's standby mode still consumes power. To completely cut off power supply, set the
Power switch to OFF (O) and then disconnect the power cord from the power outlet.

Turning off the display by Quickoff

Tap Quickoff on the screen to turn off the display without using the remote control.

Initial setup

After you have connected the display to the power, you are ready to power on the
display. The first time you power on the display, you will be guided through a series of
setup screens. Follow the on-screen instructions or the steps below to start up your
display and complete the initial setup.
1. Turn on the display. Wait for the display to boot up with the BenQ screen. This may
take a moment.
2. Tap Next on the screen to begin. Follow the on-screen instructions to set up the
language, date and time, and network. Or your can skip some of these steps and
complete the setup later.
Power
switch
IR Receiver
Power Button
Connecting power on page
RP840G
• To turn on the display, press the
Power button on the control panel or
on the remote control.
• To turn off the display, press the
Power button on the control panel or
on the remote control. The system
will automatically enter standby mode.
Basic operations
24.
Power
Switch
25