Electrical Connections - Saber Compact EZ R Series Product Manual

ELECTRICAL CONNECTIONS

Electrical Requirements
IMPORTANT
Prior to construction, confirm with your dealer if any
permits are required to comply with the state and local
codes for electrical installation.
Electrical wiring must meet the requirements of the
National Electric Code, ANSI/NFPA 70-1999.
It is recommended that you use a licensed electrician
to install all electrical connections.
A GFCI outlet is provided inside the kitchen enclosure for use
to power the grill lights and the refrigerator (R series kitchens
only). The GFCI outlet rating is 125V, 60Hz, 15A. This outlet
can be connected to your house power by either of the:
following methods:
• using a grounded, outdoor-rated extension cord (SJTW
rating, less than 100ft). This cord can connect to the
internal GFCI through the grommet in the rear panel or
through the 1" venting at the bottom of the rear panel.
• hard-wiring the internal GFCI to a stub-up connection
inside the enclosure using Romex or similar grounded,
shielded wire rated for the GFCI. This method should
be performed by an electrician.
CAUTION
If the GFCI circuit breaker trips while the kitchen is in use,
reset it. If it does not reset, contact a licensed electrician
for service. DO NOT USE THE OUTDOOR KITCHEN!
Supplying power to the outdoor kitchen that is not in
accordance with these instructions will void the
manufacturer's warranty.
A Saber EZ Outdoor Kitchen external sealed outlet accessory
. can be purchased at your local retailer for additional electrical
access. .
The lighting voltage transformer can be mounted on the electrical
panel using four drill point screws in the hardware pack. Plug it
into the GFCI outlet located inside the rear panel of the
kitchen.
The electronic ignition modules for both the grill and the side
burner should be mounted inside the kitchen door frame for
easy access to the battery inside each module. Use the
drill point screws provided in the hardware pack to screw the
ignition module mounting shield to the frame (see images
below). Use ignitor wire extension kit #80025228 for the side
burner and extension kit #80025229 for the grill (both provided
with the kitchen). The spade connections of the extension
wires should be wrapped with insulated electrical tape or
shrink wrap to prevent arcing of the ignitor wires to the kitchen
frame. This presents a shock hazard and can also affect the
performance of the electronic ignition system.
R Series
Attach the ignition
modules inside the
right side of the
door frame here
(see assembly
sheet for more
details).
6
I Series
Attach the ignition
modules inside the
left side of the door
frame here (see
assembly sheet for
more details).