Table of Contents
Advertisement
1.
Hold the front panel open (or put it in horizontal position) and remove the filter(s).
2.
Use a vacuum cleaner to remove dirt. If the dust filter is very dirty, it may be washed in
lukewarm water with a very small amount of neutral detergent. Rinse well and allow to dry
completely (not in direct sunlight or near a source of heat).
3.
Keep the grid panel open and reinstall the filter(s). Press the panel shut; a click indicates it
is closed properly.
4.
Restore the power from the consumer unit and turn the air conditioner on.
Indoor Unit: While the unit is disconnected from power dust regularly with a dry cloth or slightly
damp paper towel. Never use chemicals or solvents. Never spray a liquid in or over the
appliance.
Exterior unit: While the unit is disconnected from power. Remove dirt and keep the air intake
and exhaust openings free of debris, etc. Cleaning with chemicals may cause damage.
END OF SEASON
If the air conditioner is not going to be used for an extended period:
• Set in fan mode on a slightly warm day so that the inside of the appliance dries out.
• Switch off the power from fuse box and remove the batteries from the remote control. •
Clean filters as well
START OF SEASON
If the air conditioner is to be used again after an extended period:
• Check that the air intake and exhaust openings of the interior and exterior units are not blocked.
Remove all dirt and debris. • Check that filter is installed and is clean.
• Check that the condensation outlet drains properly and there is no dirt or organic blockage
(otherwise leakage may occur)
• Install 2 AAA batteries in the remote control.
• Turn the appliance on, set the time and desired setting.
REPLACING THE BATTERIES
• Remove the remote cover.
• Replace the AAA batteries, + to + and – to –.
• Install the cover.
• Press the on/off button; if no symbols appear on the display, the
batteries are empty or have been incorrectly installed.
8
Advertisement
Table of Contents
