Table of Contents
Advertisement
IMPORTANT
Auto restart. The air conditioner will automatically restart when electricity is restored after a power cut. If in doubt,
check the settings.
Range of internal thermostat the internal thermostat can be set at a desired temperature between 16 and 32°C.
Note that whether the desired value is achieved depends on size, temperature and insulation of the room.
Range of heat pump function
The heat function can be used when the external ambient temperature is above 5°C or higher. The performance of
the heat pump will degrade with lowering external temperatures.
Capacity
The required cooling or heating capacity depends greatly on the location and/or use of the room where the air
conditioner is installed. Strong sunlight and the presence of people, lights or equipment create an additional heat
load. Normal living spaces require about 100 W per square metre of floor surface. In strong sunlight or if other
sources of heat are present, this may be as much as 350 W/sqm.
Tip: on warm days, let the air conditioner cool the room as much as possible during the night and set the temperature
constant from night to daytime.
Emergency start
In the event of a problem, the air conditioner can be operated using the emergency button under the panel in the
interior unit. Open the front panel and press the button, the air conditioner will:
-heat if the room temperature is 20 °C or less, cool if the room temperature is 25 °C or more and for values in
between: dehumidify in a model without a heat pump and in a model with a heat pump in fan mode.
FILTERS
Turn off the appliance from the consumer unit before attempting to service the filters.
B
C
A.
Opening the front panel: at the A recesses, pull the front part up with both hands. The front
panel will stay horizontal (at around 90°).
Closing the front panel: press the front part down at the sides at B and in the middle at. Make
sure it is properly closed (click).
B A
B.
7
Advertisement
Table of Contents
