Table of Contents
Advertisement
TROUBLE SHOOTING:
If the minced meat is not discharged smoothly or in the form of paste, the causes and remedies could be:
•
Screw cap is tightened too much thus, the cutting blade does not contact properly with the cutting plate.
Readjust it.
•
The cutting plate is blocked. Clean it.
•
Cutting blade edges is dull. Sharpen or replace it.
ALWAYS UNPLUG THE MACHINE FROM THE ELECTRICAL SOCKET BEFORE PERFORMING ANY
TO CLEAN
Disassembling
Make sure that the motor has stopped completely. Disconnect the plug from the power outlet.
Locking ring has 3 notches, convenient for unscrewing.
Unscrew the locking knob, and take out the auger tube (with cutting plate, cutting blade and feed screw), then
point the auger tube mouth downward in order to take out cutting plate, cutting blade and feed screw.
Cleaning
Remove meat, etc. wash each part in warm soapy water.
•
A bleaching solution containing chlorine will discolor aluminum surfaces.
•
Do not immerse motor housing in water, but only wipe it with a damp cloth.
A little salad oil on the plate & knife after washing and drying will keep them lubricated.
REFERENCE
Item Number Model Number
11029
MG-IT-0008
Assembly and Operation
Maintenance and Cleaning
MAINTENANCE OR CLEANING!
Description
Meat Grinder #8 Cast Iron
0.5 HP / 336 W 110V/60/1
7
Manufacturer Model Number
8EL
Advertisement
Table of Contents
