Hanseatic HGVI6082D14J7713GS User Manual page 75

Problem
The display (3) is
illuminated although
dishwasher salt has
been added.
The water is not
running or it is running
only very slowly.
The water is not
running off or only very
slowly.
The dishwasher is not
watertight.
The dishwasher can be
switched on/off, but not
cannot be operated.
Possible cause
The dishwasher salt is
clumpy.
There is a kink in the inlet
hose.
The water tap is not properly
on.
The filters are blocked.
The outlet hose is kinked,
has been extended or is
hanging too high up/too low.
The door seal is defective.
The outlet hose or the inlet
hose is defective.
The dishwasher can only be
operated when the door is
closed.
Troubleshooting table
Solution
Stir the dishwasher salt using the
end of a spoon or similar.
Arrange the inlet hose properly so
that it is not kinked (please see
„Connecting the inlet hose" on
page EN-29).
Turn the water tap on completely.
Clean the filters (see „Checking
and cleaning the filters" on page
EN-26).
Lay out the outlet hose in the prop-
er manner (see page EN-28).
Have the door seal replaced
(see „Service" on page EN-38).
Have the defective hose replaced
(see „Service" on page EN-38).
Close the door.
Page EN-35