Diagnosis & Troubleshooting; Diagnostics; Fahrenheit To Celsius Conversion; Programming The Cavity Size - KitchenAid KEBI141D Technical Education

DIAGNOSIS & TROUBLESHOOTING

DIAGNOSTICS

Before servicing, perform the following checks:
• The most common cause for control failure is
corrosion on connectors. Therefore, discon-
necting and reconnecting wires will be nec-
essary throughout test procedures.
• All tests/checks should be made with a VOM
or DVM having a sensitivity of 20,000 ohms-
per-volt DC, or greater.
• Check all connections before replacing com-
ponents, looking for broken or loose wires,
failed terminals, or wires not pressed into
connectors far enough.
• Voltage checks must be made with all con-
nectors attached to the boards.
• Resistance checks must be made with power
cord unplugged from outlet, and with wiring
harness or connectors disconnected.
• Is the oven in the "Sabbath Mode"? If so,
"SAB" will appear in the display. Press and
hold the 6 touchpad for 5 seconds to end the
Sabbath Mode.
• To check for the last five Fault codes: Press
and hold the 0 touchpad to access the previ-
ous codes. Numeric touchpads 0 - 4 indicate
faults 1 - 5 respectively, with "0" being the
most recent code.
°
FAHRENHEIT ( F) TO CELSIUS (
CONVERSION
The default is Fahrenheit (° F).
1. Press the BROIL pad for 5 seconds. The
temperature will be displayed in degrees
Celsius indicated by the "C" in the tempera-
ture display.
2. To return the display to degrees Fahrenheit
press the BROIL pad again for 5 seconds.
"F" will show in the temperature display.
All manuals and user guides at all-guides.com
°
C)
6-1

PROGRAMMING THE CAVITY SIZE

When replacing the electronic control, be sure
to program the cavity size within 60 seconds of
power up by pressing the following touchpads:
BAKE (upper half of BAKE touchpad),
CONVECTION BROIL (lower half of BROIL
touchpad.
STOP TIME, CONV FULL MEAL, digit #7,
digit #9, TIMER SET/START, & START.
1. The size is shown in the display "-ID 24".
2. Press the CLOCK SET/START touchpad
until the correct size is displayed.
3. Press the CANCEL touchpad (do not press
the OVEN START touchpad).
4. To verify programming, press and hold the
1 touchpad for 5 seconds.
ELECTROSTATIC DISCHARGE
(ESD) SENSITIVE ELECTRONICS
ESD problems are present everywhere. ESD
may damage or weaken the electronic control
assembly. The new control assembly may ap-
pear to work well after repair is finished, but
failure may occur at a later date due to ESD
stress.
• Use an anti-static wrist strap. Connect wrist
strap to green ground connection point or
unpainted metal in the appliance
-OR-
Touch your finger repeatedly to a green
ground connection point or unpainted metal
in the appliance.
• Before removing the part from it's package,
touch the anti-static bag to a green ground
connection point or unpainted metal in the
appliance.
• Avoid touching electronic parts or terminal
contacts; handle electronic control assem-
bly by edges only.
• When repackaging failed electronic control
assembly in anti-static bag, observe above
instructions.