Removing The Convection Bake Element And The Fan Motor Assembly - KitchenAid KEBI141D Technical Education

REMOVING THE CONVECTION BAKE ELEMENT
AND THE FAN MOTOR ASSEMBLY
WARNING
ELECTRICAL SHOCK HAZARD
Disconnect power before servicing.
Replace all panels before operating.
Failure to do so could result in death or
electrical shock.
CAUTION: When you work on the built-in
oven, be careful when handling the sheet metal
parts. Sharp edges may be present, and you
can cut yourself if you are not careful.
1. Disconnect the electrical power to the
oven.
2. To make servicing easier, remove the
oven door from the unit (see page 2-3 for
the procedure).
3. Remove the racks from inside the oven.
Convection Bake
Element & Fan Motor
4. Remove the three screws from the con-
vection cover and remove the cover from
the rear of the oven liner. Note the location
of the notch in the cover. Be sure to
All manuals and user guides at all-guides.com
4-14
position the cover with the notch as shown
when you reinstall it.
5. To remove the convection bake ele-
ment:
a) Remove the two screws from the con-
vection bake element.
b) Pull it forward so you can access the
terminals.
c) Disconnect the wires from the element
terminals.
Screw
Element Terminals
Screw 1 of 3
Convection
Cover
Notch
Convection Bake
Element
Screw