Troubleshooting - Epson LQ-680 User Manual

Panel light
state
f Paper Out
n Pause
f Paper Out
f Pause
f Pause
f All the lights
on the control
panel
n = on, f = flashing
••• = short series of beeps (three beeps)
• • • • • = long series of beeps (five beeps)
Note:
The printer beeps once if you press a control panel button when the corresponding
function is not available.
Beep Problem
pattern
Solution
••• Continuous paper is not fed back to the
standby position.
Tear off the printed document at the
perforation; then press the Load/Eject button.
The printer feeds the paper to the standby
position. Press the Pause button to turn off the
Pause light.
••• A single sheet of paper is not fully ejected.
Press the Load/Eject button to eject the sheet.
Then press the Pause button to turn off the
Pause light, if necessary.
••• Paper is jammed in the printer.
Clear the paper jam as described in "Clearing
Paper Jams" on page 5-16.
••• The printer was unable to switch between paper
sources because of a paper jam or other paper
problems. (LQ-680Pro only)
Remove any paper from the paper path and
clear the paper jam as described in "Clearing
Paper Jams" on page 5-16. Then retry the
paper source selection.
– The print head is overheated.
Wait a few minutes; the printer resumes printing
automatically once the print head has cooled.
• • • • • An unknown printer error has occurred.
Turn off the printer and leave it off for several
minutes; then turn on the printer again. If the
error recurs, contact your dealer.

Troubleshooting

5
5-3