Safety Section
2.3
Safety plates and symbols
Plates are affixed to the dust collector showing safety symbols and/or messages.
Attention!
Make sure all the safety messages are legible.
Clean these with a cloth, soap and water. Do not use solvents, diesel fuel or petrol.
Replace the damaged plates with new ones supplied by NFE.
If a plate is affixed to a replaced part, make sure a new plate is affixed to the new part.
Attention!
Read the operator's and maintenance manual carefully before using the dust collector or doing any
maintenance jobs.
WARNING!
ONLY SHAKE THE FILTER WHEN THE MACHINE IS TURNED OFF
IMPORTANT
DO NOT BREATHE IN FLAMMABLE AND/OR
EXPLOSIVE LIQUIDS OR POWDERS
Warning!
Risk of crushing upper limbs while fitting and locking the material Longopac® container on the dust
collector.
Never place hands between the material Longopac® container and dust collector while locking.
Do not place hands on sides of Longopac® container near the guide pins while locking.
Perform the Longopac® container locking operation by means of the levers located on the side, USING
BOTH HANDS!
- 9 -