National Flooring Equipment DL3000 Service Manual page 17

Remove from underneath the dust collector the pin (A) and spring pin (B) that fasten the filter to the

shaking lever.
Lift the filter complete with support.

Loosen the clamp and remove the support ring with seal.

Remove the knots and take out the pocket filter. Fit the new filter, put everything back together

carefully and fit the cap back on.
Important!
All the material trapped by the filter and the filter itself must be disposed of through authorized channels
in the country where the dust collector is used.
The Longopac® container locking operation must be performed by one person only, who must lower the
back side lever with both hands.
Caution!
Hand crushing hazard!
- 14 -
Maintenance Section