Table of Contents
Advertisement
50PFL5601 serial numbers beginning with DS3 or higher numbers
Digital audio preferences
You can set the interpretive broadcasting by an audio explanation.
1
Use
to select Digital audio preferences, then press OK.
Voice guide
Caption settings
Digital audio preferences
To prioritize VI-Visually Impaired streaming or HI-
Hearing Impaired streaming: The setting for
Audio accessibility
handicapped users (Main audio, Visually
Impaired or Hearing Impaired).
To set your preferred language in the audio
Audio language
streaming (English, Spanish or French).
To set TV priority based on either of the above
Primary audio
settings: (Audio accessibility or Audio language).
selection criteria
Search for channels
Be sure the RF cable is correctly connected to this unit and you are
registered with your cable TV provider when you install cable channels.
1
Press
and use
2
Use
to select Search for channels, then press OK.
3
Use
to select Start, then press OK.
Install channels
You can search and store all channels. If you move the unit to a different
area after the initial setting, it is recommended to perform
Autoprogramming.
4
Use
to select Antenna or Cable, then press OK.
5
Press OK on Start.
•
When the scanning and memorizing of available channels is
completed, the lowest memorized channel will be displayed.
6
Follow the on-screen instructions to complete the installation.
System searching. Please
wait...
Auto programming may take
more than 20 minutes to
complete.
12
Stop
Audio accessibility
Audio language
Primary audio selection criteria
to select Setup, then press OK.
Digital channels found:
Analog channels found:
Total progress:
Channel settings
1
Press
and use
2
Use
3
Adjust the following items.
Channel installation
Child lock
Change PIN
Digital audio language
Mono/Stereo
Channel installation
Be sure the RF cable is correctly connected to this unit and you are
registered with your cable TV provider when you install cable channels.
Installation mode
1
Use
to select Channel installation, then press OK.
2
Use
to select Installation mode, then press OK.
3
Use
to select Antenna or Cable, then press OK.
•
When Antenna is selected, the TV detects antenna signals. It
searches for DTV and analog TV channels available in your area.
•
When Cable is selected, the TV detects signals supplied by cable.
It searches for DTV, analog TV and cable channels available in your
area.
Uninstall channels
The channels selected here can be skipped when selecting the channels
using CH + / –.
Those channels can still be selected with the NUMBER buttons.
1
Use
to select Channel installation, then press OK.
2
Use
to select Uninstall channels, then press OK.
3
Use
to select the channel you want to remove, then press OK.
•
The removed channels are not displayed on the list of favorite
channels.
•
To reactivate a removed channel, use
0
0
34
to select Setup, then press OK.
to select Channel settings, then press OK.
Installation mode
Uninstall channels
then press OK.
Continued on next page.
.
35
English
Advertisement
Chapters
Table of Contents
Troubleshooting
