CEM MARS Series Installation Manual

Installation Guide
MARS Series
Installation Location
1. Designate an area with a sturdy work-
bench within 8' (2.5 m) of a hood or
suitable fume disposal mechanism.
2. Provide at least 8" (20.3 cm) space
on each side and 3" (7.6 cm) space
in the rear for ventilation.
System Dimensions:
21" (53.3 cm) W x 25" (63.5 cm) D x
25" (63.5) H
140 lb in weight (without vessels)
3. Allow space for sample handling
4. The system must be free from the
vibration of large equipment or
walk-through traffic
5. The system must be away from the
primary exits and walk-through traffic
6. Location should have a temperature
of 41°F (5 °C) – 104 °F (40 °C).
7. The system should be connected to
a dedicated, grounded outlet.
Ventilation Requirements
The system comes with 8' (2.5 m) of
flexible exhaust hose (3 1 ∕ " OD x 2 13 ∕
8
ID). The built-in exhaust system will push
fumes through the hose at 125 CFM.
To properly vent the system, your hood
or exhaust line must draw at least 125
CFM at the point of connection.
Electrical Requirements
The MARS unit requires 208/230 V, 60
Hz, 15A @ 230 V, or 200/220/240 V, 50
Hz, 15A @ 240 V, single phase power. It
requires a 250 V 15 A rated receptacle
(NEMA 6-15R) or a 250 V - 20 A rated re-
ceptacle (NEMA 6-20R). It is non-locking.
• Pull plastic tab, swing handle open.
1
• Remove plastic assembly from box.
• Repeat process on other 3
assemblies.
• Lay the sides of the box flat.
4
• Remove the foam from the top of
the system.
• Remove the box from inside of the
7
system cavity.
"
16
• Write down the serial number located
on the back left side of the system.
• Determine the line voltage from outlet:
10
60 Hz - 208 V or 230 V
50 Hz - 200 V, 220 V or 240 V
• Select the line voltage.
• Restart system.
• Use top handles to pull up and
2
remove outer box.
• Lift the system, from the sides, onto
5
bench top near exhaust service (two
people required). Do not place the
system in a fume hood.
• Attach the exhaust hose, and connect
8
to back of the system.
• Plug power cord into the system and
a dedicated, grounded outlet.
• After restart, select "Settings", then
11
"Video", then "Welcome" for a short
introduction. (Not available on all
systems)
• Carefully cut the tape on both sides
3
of the inner box.
• Remove the plastic and discard.
6
Do not leave the plastic under
the system.
• Push the power button on the side of
9
the system to turn it on.
• Go to www.cem.com/register to
12
register your system.
• See back of this sheet for details.