Cleaning Thoroughly - Panasonic ES‑LV9E Operating Instructions Manual

Cleaning thoroughly

Cleaning with water
• Turn the shaver off and disconnect the AC adaptor.
1
Apply some hand soap and
some water to the system
outer foil�
2
Press for more than
2 seconds to activate the
sonic vibration cleaning mode�
• Splashing of foam is suppressed.
• The battery capacity lamps blink
in order.
• After about 20 seconds, it will be
automatically turned off, or you can turn it off by
pressing the power switch.
3
Remove the outer foil
section and clean with
running water�
• See page 20 for removing the
outer foil section.
• Splashing is reduced by rinsing the shaver in sonic
vibration cleaning mode.
• After rinsing with water, shake the shaver up and
down for a few times to remove excess moisture and
then wipe off any drops of water with a dry cloth.
18
4
Attach the outer foil
section and dry with the
self-cleaning recharger�
1. Insert the shaver into the
self‑cleaning recharger and
plug the adaptor into a
household outlet.
• Check that the charge status
lamp ( ) is glowing.
2. Press twice.
The DRY lamp glows, and the "Dry/Charge"
mode will start after approximately 6 seconds.
• It is possible to change to the "AUTO" mode
even after the "Dry/Charge" mode has started.
Dry
180 min
3. Remove the adaptor after the selected mode is
completed.
5
Lubricate the shaver�
It will keep the movement of the
blade smooth and maintain a
comfort shave.
1. Apply one drop of oil to each of
the system outer foils.
2. Raise the trimmer and apply a drop of oil.
3. Switch the shaver on, and run it for approximately
five seconds.
1
1
2
Charge
0 to 60 min