Epson ColorPage 8000 Printer Manual page 40

Error messages (continued)
Message Explanation
Paper Unit Open The multipurpose tray is pulled out.
Photoconductr The photoconductor unit has a problem.
Trouble
Replace Oil Roll
The fuser oil roll is empty.
Replace The photoconductor unit has reached
Photoconductr
the end of its service life.
Replace Waste T The waste toner collector is full.
Box
Service req e
A controller error or a print engine error
<error number> has been detected.
<CMYK> Toner
The indicated toner cartridge is missing.
Crtg Out
<CMYK> Toner The indicated toner cartridge is empty.
Out
Turn Paper Paper is loaded incorrectly.
Write Error An internal error has occurred in the
DIMM A
printer.
Wrong The wrong photoconductor unit has
Photoconductor been installed.
Monitoring the Printer
Response
Push in the multipurpose tray.
Turn off the printer and replace
the photoconductor unit.
Replace the fuser oil roll.
Replace the photoconductor unit.
Replace the waste toner collector. page 4-15
Write down the error number and
turn off the printer. Wait at least
10 seconds and then turn it back
on. If this error still appears, turn
off the printer, unplug the power
cord, and contact IKON.
Install the indicated toner
cartridge.
Replace the toner cartridge.
Turn the paper 90 degrees.
Reset the printer by holding down
the Alt and Reset buttons until
Reset appears on the display. If
the error is not cleared, contact
IKON.
Turn off the printer and replace
the photoconductor unit.
2-9
| 2-9
See
page 4-10
page 4-6
page 4-10
page 4
page 4-2
page 4-2
page 1-7
page 4
page 4-10