Table of Contents
Advertisement
5-5
Installing Memory
Installing Memory
1. Insert each memory module vertically into its slot, paying attention to the
notch along the bottom of the module to prevent inserting the module
incorrectly (see Figure 5-2).
2. Install starting with slot P1/DIMMA1.
3. Gently press down on the memory module until it snaps into place.
4. With two CPUs installed, repeat step 2 to populate the CPU2 DIMM slots.
5. See the tables that follow for details on populating the DIMM slots.
Note: It is highly recommended that you remove the power cord from the system
before installing or changing memory modules. Please refer to our web site for
memory that has been tested on the X10DRT-P/PT/PIBF serverboard. For best
performance, use memory modules of the same type and speed in the same bank.
Memory Support
The X10DRT-P/PT/PIBF has sixteen DIMM slots supporting up to 1024 GB
of LRDIMM (Load Reduced DIMM) or 512 GB of RDIMM (Registered DIMM)
DDR4-2133/1866/1600 MHz registered ECC memory.
Note: Check the Supermicro website (www.supermicro.com) for the latest memory
support information.
Release Tab
Socket Key
Chapter 5: Advanced Serverboard Setup
Figure 5-2. DIMM Installation
5-9
Release Tab
Advertisement
Table of Contents
