Supermicro SUPERSERVER 5019S-M User Manual page 49

SuperServer 5019S-M/MR User's Manual
The following IPMI information will be displayed:
•
IPMI Firmware Revision
•
IPMI Status
System Event Log

Enabling/Disabling Options
SEL Components
Select Enabled to enable all system event logging support at bootup. The options are Enabled
and Disabled.
Erasing Settings
Erase SEL
Select Yes, On next reset to erase all system event logs upon next system reboot. Select
Yes, On every reset to erase all system event logs upon each system reboot. Select No to
keep all system event logs after each system reboot. The options are No, Yes, On next reset,
and Yes, On every reset.
When SEL is Full
This feature allows the user to determine what the AMI BIOS should do when the system
event log is full. Select Erase Immediately to erase all events in the log when the system
event log is full. The options are Do Nothing and Erase Immediately.
Note: After making changes on a setting, be sure to reboot the system for the changes to
take effect.
BMC Network Configuration

The following items will be displayed:
•
IPMI LAN Selection
•
IPMI Network Link Status
Update IPMI LAN Configuration
Select Yes for the system BIOS to automatically reset the following IPMI settings upon next
system boot. The options are Yes and No.
88
Configuration Address Source (Available when the item above - Update IPMI LAN
Configuration is set to Yes)
Use this item to select the IP address source for this computer. If Static is selected, you will
need to know the IP address of this computer and enter it to the system manually in the field.
If DHCP is selected, AMI BIOS will search for a DHCP (Dynamic Host Configuration Protocol)
server attached to the network and request the next available IP address for this computer.
The options are DHCP and Static.
Station IP Address
This item displays the Station IP address for this computer. This should be in decimal and in
dotted quad form (i.e., 192.168.10.253).
Subnet Mask
This item displays the sub-network that this computer belongs to. The value of each three-
digit number is separated by dots and it should not exceed 255.
Station MAC Address
This item displays the Station MAC address for this computer. Mac addresses are 6 two-digit
hexadecimal numbers.
Router IP Address
This item displays the Router IP address for this computer. This should be in decimal and in
dotted quad form (i.e., 172.31.0.1).
89
Chapter 6: BIOS