Troubleshooting - Tanita DC-240 Instruction Manual

- Please check the following before asking for repair.
Symptom
Impedance
measurement error
Zero point error
How to
measure
The measured weight is
not stable.
Nothing is displayed even
after turning on the power.
Display
is displayed.
Note
In the case that an error is displayed other than the above, turn off the power once, and then
measure again.
If the same error is displayed repeatedly, contact our customer service center.

Troubleshooting

Please check
･Measure with bare feet.
･If the soles of your feet are dry, use a
dropper to drop about 0.5mL of water on
the electrodes before measurement.
･Check the input information.
･Turn off the power, and remove the items
on the platform and turn on the power
again, and then redo the measurement.
･Is it installed at a place with vibrations?
･Is the platform inclined?
⇨ Keep the platform horizontal.
･Is anything caught in the gaps of the
platform?
⇨ Remove anything caught in the gaps.
･Check that the power supply is connected
correctly.
･The weight to measure exceeds the
measurement range.
19