Table of Contents
Advertisement
Table 2-1: Rear Panel Controls and Connectors (Continued)
WAN/LAN Antenna Connections Variation 2
ETH 1, 2, 3, and 4
RS232
USB
POWER
Rev 1 May.16
2.2.2 Status Indicators
The oMG base unit has three external LEDs that indicate system status. These
are located on the front-left corner of the top of the case, adjacent to the logo.
Figure 2-4
shows these indicators.
Figure 2-4: Status Indicators
•
WAN1-A/B, WAN2-A/B: RP-SMA Connectors for
primary and secondary Wi Fi connectivity, each
supporting MIMO
•
WAN3-A/B: Used for Wi Fi WAN
•
WAN4-A/B: Used for USB/Express Pocket Cellular
•
LAN1-A/B: Used for Wi Fi LAN for connecting up to two
Wireless Local Area Network (WLAN) antenna inter-
faces.
RJ45 ports 10/100 Base-T Ethernet connections. Can
individually be configured as a LAN or WAN connection.
Default configuration: the oMG acts as a DHCP server. The
oMG ETH1, ETH2, and ETH3 ports are configured by default
to be LAN ports. ETH4 is configured by default as a WAN
port. Connector type: RJ45.
DB9 DTE serial interface which can be configured for various
applications. In the default configuration, the detailed system
log is output to this interface for troubleshooting purposes.
Default setting: 115,200 bps, 8 bits, no parity.
The system supports two type-A, Universal Serial Bus (USB)
1.1/2.0 ports. The default configuration is disabled.
Self locking 3-pin 12-Volt DC, 2.7 Amp power connector. The
connector on the power cable is keyed for alignment and has
a sleeve that can be tightened to prevent accidental
disconnection.
9
System Description
4119192
Advertisement
Table of Contents
