Receiving Faxes - Epson WorkForce Pro WP-4530 Quick Manual

■
If you are scanning with the ADF (see page 5), your document is automatically
scanned and faxed.
■
If you placed your document on the scanner glass, you can scan additional pages
after the first one is sent.
■
If the fax number is busy, you see a redialing message and the product redials
after one minute. To redial immediately, press
Note: If you turn off the product, the following data stored in the product's temporary
memory will be lost: received faxes that haven't yet been printed, faxes scheduled to
be sent later, and faxes being retransmitted automatically.

Receiving Faxes

Before receiving faxes, make sure you load plain paper and select the correct settings for the
paper you've loaded.
1. Press F .
Setup
2. Select
Fax Settings
3. Select
Receive Settings
4. Select
Paper Source to Print.
5. Select the paper source you want to change, then change the setting.
Note: If the incoming fax is larger than the paper you loaded, it is reduced to fit or
printed on multiple pages, depending on the Auto Reduction setting you select.
6. To receive faxes automatically, make sure you see a green light next to
on the control panel. If the light is off, press
Answer)
Note: To change the number of rings before the product answers, see page 12.
If you run out of paper during printing, you see an error message. Load more paper and
press one of the x
Start
.
.
buttons to continue.
.
Redial/Pause
.
Receiving Faxes
(
Auto
13