Epson WorkForce 500 Quick Manual page 37

4. Shake the cartridge several times,
then remove it from the package.
Do not to touch the green chip on
the side.
5. Remove the yellow tape from the
bottom of the ink cartridge.
Caution:
Do not remove any other labels or seals, or ink will leak.
6. Insert the new ink cartridge into the holder and push it down until it clicks
into place.
7. Once you replace all the cartridges that need replacing, close the cartridge
cover and push it down until it clicks into place.
8. Close the scanner.
9. Press to begin charging the ink. This takes about 2 minutes. When you
OK
see a completion message on the display screen, ink charging is finished.
Caution:
To conserve ink, never turn off the WorkForce 500 Series while ink is charging. If you
see an ink replacement message on the display screen, press
the cartridges securely.
If you remove a low or expended ink cartridge, you cannot reinstall and use the
cartridge.
OK
and press down all
Replacing Ink Cartridges
37