Paper Feed Problems - Epson Stylus Photo RX700 Basics Manual

Paper Feed Problems

If paper jams frequently, make sure the left edge guide isn't pushed too tightly
against the paper. Also, try loading fewer sheets of paper. The stack should never
be above the arrow on the inside of the left edge guide. Some paper types require
that you load sheets individually or use a support sheet; follow the instructions
that came with your paper for specific instructions.
If paper jams in the rear sheet feeder:
■
You may have pushed the paper down too far into the sheet feeder. Turn the
Stylus Photo RX700 off and carefully remove the paper.
■
Reload the paper against the right side, and slide the left edge guide against
the paper (but not too tightly).
If paper jams in the front paper tray:
■
The front paper tray is designed for loading plain (photocopier) letter-size
paper. Load other types or sizes of paper (such as Epson photo paper) in the
rear sheet feeder.
■
Don't push the paper in too far. Align it with the line on the yellow sticker
(see page 10).
■
Fan the stack of paper and then tap it on a desk to even the edges. Make sure
the edges remain even after loading in the tray.
To clear a paper jam:
If paper jams, turn off your Stylus Photo RX700, lift open the scanner section, and
remove any paper that's inside, including any small pieces that may have torn off.
Carefully reload paper, turn the Stylus Photo RX700 back on, and press the
button.
Color
x
Caution:
Clear paper jams by pulling the paper out of the printer in the direction that it normally
feeds through the printer (towards the output tray). Never pull the paper out backwards
(in the direction of the sheet feeder).
80
Solving Problems