Advertisement
24
model no. 054-0367-0 | contact us: 1.866.523.5218
L5
L7
L9
f.
Use the wrench provided (screwdriver part) to tighten the chain to a suitable tension
by turning the wrench clockwise (see Fig. L9). Fit the chain cover and tighten the chain
cover by turning the chain cover lock nut clockwise until it is tight (see Fig. L10).
g. Check the chain tension: The correct chain tension is reached when the chain can
be raised approx. 0.12-0.2'' (3-5 mm) from the guide bar in the centre (using a small
amount of force). This should be done by using one hand to raise the chain against the
weight of the machine. Do not tension the chain too much.
h. If the chain is still loose or too tight, loosen the chain cover, and then use the wrench to
adjust the chain slightly. Tighten the chain cover again.
L6
Kink
L8
L10
Advertisement
