Advertisement
model no. 054-0367-0 | contact us: 1.866.523.5218
WARNING:
•
Remove the battery pack before adjusting saw chain tension.
•
Cutting edges on chain are sharp. Use protective gloves when
handling chain.
•
Maintain proper chain tension always. A loose chain will increase
the risk of kickback. A loose chain may jump out of guide bar
groove. This may injure operator and damage chain. A loose chain
will cause chain, bar, and sprocket to wear rapidly.
5. LUBRICATION
NOTE: Chain life and cutting capacity depend on optimum lubrication. Therefore, the
chain is automatically oiled during operation.
a. Set pole saw on any suitable surface with oil filler cap facing upward.
b. Clean area around the oil filler cap with a cloth, and unscrew the cap by turning it
counter-clockwise (see Fig. D).
c. Add chain oil until tank is full.
d. Avoid dirt or debris entering oil tank. Refit oil filler cap and tighten by turning
clockwise until hand-tight.
It is important to use only the recommended bar and chain oil to avoid damage to the
pole saw. Never use recycled/old oil. Use of non-approved oil will void the warranty.
Do not swallow. If swallowed, call a physician immediately. Keep out of reach of
children. Store away from heat or open flame.
Checking the Automatic Oiler
Proper functioning of the automatic oiler can be checked by running the pole saw and
pointing the tip of the chain guide bar towards a piece of cardboard or paper on the
ground. If an increasing oil pattern develops on the cardboard, the automatic oiler is
operating fine. If there is no oil pattern, despite a full oil reservoir, contact a CTC customer
service agent or a CTC-approved service agent.
D
15
Advertisement
