Table of Contents
Advertisement
shown. The rear log has a projection that
will fit into the recess area on the bottom
of the top rear log (see Figure 34).
Top Rear
Log
Rear Log
Figure 34 - Installing Top Rear Log
f i r e - p a r t s . c o m
126543-01A
INSTALLATION
Continued
www.lennoxhearthproducts.com
EMBER PLACEMENT
WARNING: Do not use
any other ember material not
supplied with this unit.
WARNING: Do not operate
unit without ember material cor-
rectly in place as shown in Fig-
ures 36 & 37, page 20. Do NOT
place ember material anywhere
else on the unit. Use only em-
ber material supplied with unit.
Excessive or incorrectly placed
ember material may produce
carbon monoxide or soot.
1. Ember Chunk Placement. The SVFS36
series burner systems include three em-
ber chunks that are designed to fit over
shoulder screws on the ember pan burner.
The bottom of each ember chunk has a
hole for securing the ember chunk in place
when it is placed over a shoulder screw.
Place the ember chunks as shown in Fig-
ure 35 on page 20 by placing the ember
chunk with the number "1" on the left, "2"
in the center, and "3" on the right. These
numbers are embossed on the back of
each piece for identification purposes.
Please note that SVFS32 series burner
systems do not include ember chunks.
2. Two ember materials are supplied with
this log set. Platinum Bright Embers give
a bright glow appearing as hot coals.
Should embers need replacing, see
Parts, page 30.
Platinum Bright Ember placement. Add
embers to front, flat burner. Gently remove
embers from bag. Separate pieces of
ember material and place on surface of
flat burner just behind horizontal ports as
shown in Figure 36.
Rock Wool placement. Place rock wool
material on front flat burner in areas away
from ports as shown in Figure 37.
3. DO NOT place rock or additional logs
on front burner or on logs. Placing any
material on unit other than ember material
on front burner may result in production
of carbon monoxide or soot.
19
Advertisement
Table of Contents
