Superior SLDVT-35 Series Care And Operation Instructions Manual

Hide thumbs

Table Of Contents

Table of Contents

Quick Links

• Hot! Do not touch! The glass and

surfaces of this appliance will be hot

during operation and will retain heat

for a while after shutting off the appli-

ance. Severe burns may result.

• Carefully supervise children in the

same room as appliance.

• If small children are present in the home, it is

recommended that this appliance be ﬁtted with

a screen door or screen panel kit. See Pages

13 & 14 for ordering information.

WARNING: IF THE INFORMATION IN THIS MANUAL

IS NOT FOLLOWED EXACTLY, A FIRE OR EXPLO-

SION MAY RESULT CAUSING PROPERTY DAMAGE,

PERSONAL INJURY OR LOSS OF LIFE.

Do not store or use gasoline or other ﬂammable

vapors or liquids in the vicinity of this or any

other appliance.

WHAT TO DO IF YOU SMELL GAS:

• Do not light any appliance.

• Do not touch any electrical switch; do not

Use any phone in your building.

• Immediately call your gas supplier from a

neighbor's phone. Follow your gas supplier's

instructions.

• If your gas supplier cannot be reached, call

the ﬁre department.

Installation and service must be performed by

a qualiﬁed installer, service agency or the gas

supplier

Portland

A French manual is available upon request. Order P/N 506010-01CF

Ce manuel d'installation est disponible en francais, simplement en

faire la demande. Numéro de la pièce 506010-01CF

WARNINGS

OTL Report No. 116-F-50-5

CARE AND OPERATION

INSTRUCTIONS

DIRECT VENT

SLDVT-35/40 SERIES

DIRECT-VENT GAS FIREPLACE HEATERS

P/N 506010-01

REV. N/C 08/2008

MODELS

Millivolt Models

SLDVT-35NM

SLDVT-35PM

SLDVT-40NM

SLDVT-40PM

INSTALLER: Leave this manual with the appliance.

CONSUMER: Retain this manual for future reference.

AVERTISSEMENT: ASSUREZ-VOUS DE BIEN

SUIVRE LES INSTRUCTIONS DONNÉ DANS CETTE

NOTICE POUR RÉDUIRE AU MINIMUM LE RISQUE

D'INCENDIE OU POUR ÉVITER TOUT DOMMAGE

MATÉRIEL, TOUTE BLESSURE OU LA MORT.

POUR VOTRE SÉCURITÉ: Ne pas entreposer ni

utiliser d'essence ni d'autre vapeurs ou liquides

inﬂammables dans le voisinage de cet appareil ou

de tout autre appareil.

POUR VOTRE SÉCURITÉ: Que faire si vous sentez

une odeur de gaz:

• Ne pas tenter d'allumer d'appareil.

• Ne touchez à aucun interrupteur. Ne pas vous

servir des téléphones se trouvant dans le bati-

ment où vous vous trouvez.

• Evacuez la piéce, le bâtiment ou la zone.

• Appelez immédiatement votre fournisseur de

gaz depuis un voisin. Suivez les instructions

du fournisseur.

• Si vous ne pouvez rejoindre le fournisseur de

gaz, appelez le service dos incendies.

L'installation et service doit être exécuté par un

qualiﬁé installeur, agence de service ou le fournis-

seur de gaz.

Electronic Models

SLDVT-35NE

SLDVT-40NE

Table of Contents

Troubleshooting

Need help?

Do you have a question about the SLDVT-35 Series and is the answer not in the manual?

Questions and answers

Summary of Contents for Superior SLDVT-35 Series

Page 1 CARE AND OPERATION INSTRUCTIONS DIRECT VENT SLDVT-35/40 SERIES WARNINGS DIRECT-VENT GAS FIREPLACE HEATERS • Hot! Do not touch! The glass and surfaces of this appliance will be hot P/N 506010-01 REV. N/C 08/2008 during operation and will retain heat for a while after shutting off the appli- MODELS ance.
Page 2: Table Of Contents
CONGRATULATIONS! Due to high temperatures the appliance should be located out of trafﬁc and away from furniture and draperies. Locate furniture and window In selecting this LENNOX Direct-Vent Gas Appliance you have chosen the ﬁnest and most coverings accordingly. dependable ﬁreplace to be found anywhere. Its a beautiful, prestigious alternative to a wood burning ﬁreplace.
Page 3: Gas Controls Access
Oriﬁce Sizes - Sea Level to High Altitude Removing Control Compartment Door: Manifold Gas Supply Pressure (All Models): These appliances are tested and Open the panel by gently lifting it upward and (millivolt models) approved for installations at elevations of 0-4500 forwards.
Page 4: Variable Flame Adjustment
Millivolt Appliances - Appliances with Millivolt systems will be ﬁtted with the gas control valve shown in Figure 3. Electronic Appliances - Appliances with electronic systems will be ﬁtted with the electronic valve shown in Figure 4. Millivolt Appliances - To light millivolt ap- pliances refer to Figure 2.
Page 5: Maintenance
2. During the ﬁrst initial burns of these appli- Inspect Venting System Clean Logs And Burner The appliance and venting system should be ances, there will be some odor emitted (see Carefully remove the logs (use care when han- thoroughly inspected before initial use and dling the ﬁber logs, as they become quite fragile Burn-In Period on Page 3 ).
Page 6: Front Glass Enclosure Panel, Removal And Installation
Front Glass Enclosure Panel, Removal Removing Glass Enclosure Panels (see Figure 5) and Installation Header Spacing 1. To access the glass door securing latches, Guides WARNING: Do not operate appli- ﬁrst open the lower control compartment door ance with the glass front removed, (Figure 5 ) by lifting and pulling the bottom cracked or broken.
Page 7: Install Volcanic Stone
INSTALL VOLCANIC STONE, GLOWING Note: This appliance is provided with enough WARNING: DO NOT attempt to Glowing Embers for several applications, do EMBERS AND LOGS install the logs until the appliance not use all that is in a new bag at one time. For best glowing effect, replace the ember installation has been completed, 1.
Page 8 SLDVT-35 LOG PLACEMENT Number Description Left Front Log Right Front Log Left Rear Log Right Rear Log Catalog Number for the entire log set: H7244 Left Rear Bracket Right Rear Bracket Right Front Log "Nub" Left Front Bracket Rockwool Right Front Bracket Step 3 Step 1 Align hole at the bottom of left front log (1) over the left front...
Page 9 SLDVT-40 LOG PLACEMENT Number Description Ember Chunk Left Front Log Right Front Log Left Rear Log Right Rear Log Catalog Number for the entire log set: H7245 Left Rear Right Rear Bracket Place Ember Chunk Here Bracket Right Front Log "Nub" Left Front Bracket Rockwool Right Front Bracket...
Page 10: Burner Flame Adjustments
BURNER ADJUSTMENTS (QUALIFIED TECHNICIANS ONLY) Flame Appearance and sooting Proper ﬂame appearance is a ﬂame which is blue at the base and becomes yellowish-orange in the body of the ﬂame. When the appliance is ﬁrst lit, the entire ﬂame may be blue and will gradually turn yellowish-orange during the ﬁrst 15 minutes of operation.
Page 11: Millivolt Appliance Checkout
WARRANTY CAUTION: Carbon will be pro- SIT MILLIVOLT PILOT ASSEMBLY Your gas appliance is covered by a limited duced if the air shutter is closed Proper Pilot Flame Appearance twenty year warranty. You will ﬁnd a copy Igniter Rod too much. Any damage due to Hood of the warranty accompanying this manual.
Page 12: Wiring Diagrams
WIRING DIAGRAMS Wiring diagrams are provided here for reference purposes only. This information is also provided on schematics attached directly to the appliance on a pullout panel located within the control compartment. CAUTION: Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous appliance operation.
Page 13: Accessory Components
ACCESSORY COMPONENTS Product Reference Information Cat. Model Ship. Ship. Weight Volumn H3319 SLDVT-35NM 113 lb. 15.75 cu. ft. H3320 SLDVT-35PM 113 lb. 15.75 cu. ft. H3321 SLDVT-35NE 113 lb. 15.75 cu. ft. H3322 SLDVT-40NM 147 lb. 20.18 cu. ft. H3323 SLDVT-40PM 147 lb.
Page 14 ACCESSORY COMPONENTS CONTINUED Style View Screen Doors - These Style View doors are easy to install and will not require hardware to atach them to the standard glass door frame. The Style Style View“ Doors and Facades- View door installs over the standard glass enclosure panel and provides a barrier to prevent direct contact with the hot glass surface. These Style View Doors and Facades are easy to install and will not require hardware to attach them to the standard glass door The door includes heavy duty magnet door latches and functional twin-pane screen doors.
Page 15 ACCESSORY COMPONENTS CONTINUED Touch-Up Paint Kit Repair of minor scratches and discoloration of the Forced Air Blower Kits White Wall Switch Kit appliance charcoal painted surfaces may be accom- Cat. Model No. Description plished with the touch-up paint kit. Cat. No. Model No.
Page 16: Lighting Instructions - Millivolt
LIGHTING INSTRUCTIONS – MILLIVOLT GAS VALVE FOR YOUR SAFETY READ BEFORE LIGHTING WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE. A. This appliance has a pilot which must be lighted with a piezo •...
Page 17 INSTRUCTIONS D’ALLUMAGE – VANNE GAZ MILLIVOLT POUR VOTRE SÉCURITÉ, LISEZ CES INSTRUCTIONS AVANT L’ALLUMAGE AVERTISSEMENT : SI VOUS NE SUIVEZ PAS CES INSTRUCTIONS À LA LETTRE, IL POURRAIT S’EN SUIVRE UN INCENDIE OU UNE EXPLOSION CAUSANT DES DOMMAGES MATÉRIELS, DES BLESSURES CORPORELLES OU MÊME DES PERTES DE VIE. •...
Page 18: Lighting Instructions - Electronic
LIGHTING INSTRUCTIONS — ELECTRONIC FOR YOUR SAFETY READ BEFORE LIGHTING WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE. • Immediately call your gas supplier from a neighbor’s A.
Page 19 INSTRUCTIONS D’ALLUMAGE — ELECTRONIC POUR VOTRE SÉCURITÉ, LISEZ CES INSTRUCTIONS AVANT L’ALLUMAGE AVERTISSEMENT: SI VOUS NE SUIVEZ PAS CES INSTRUCTIONS À LA LETTRE, IL POURRAIT S’EN SUIVRE UN INCENDIE OU UNE EXPLOSION CAUSANT DES DOMMAGES MATÉRIELS, DES BLESSURES CORPORELLES OU MÊME DES PERTES DE VIE. A.
Page 20: Maintenance Schedule
MAINTENANCE SCHEDULE Annually (Before the onset of the Burning Season) MAINTENANCE TASK ACCOMPLISHING PERSON PROCEDURE Inspecting/Cleaning Burner, Logs Qualiﬁed Service Technician Inspect valve and ensure it is properly operating. Check piping and Controls for leaks. Vacuum the control compartment, ﬁreplace logs and burner area.
Page 21: Troubleshooting Guide - Millivolt
TROUBLESHOOTING Note: Before troubleshooting the gas control system, Ensure external gas shut off valve, located at gas supply inlet, (and wall switch, iff applicable), is in the “ON” position. Important: Valve system troubleshooting should only be accomplished by a qualiﬁed service technician. TROUBLESHOOTING GUIDE - MILLIVOLT GAS CONTROL SYSTEM SYMPTOM POSSIBLE CAUSES...
Page 22: Troubleshooting Guide - Electronic
TROUBLESHOOTING THE ELECTRONIC IGNITION SYSTEM Note: Before troubleshooting, be sure that the appliance main line gas shut-off valve, the gas control valve and the wall switch are in the “ON” position. Important: Valve system troubleshooting should only be accomplished by a qualiﬁed service technician. SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION...
Page 23: Replacement Parts List
REPLACEMENT PARTS LIST Item Description SLDVT-35 SLDVT-40 Part No. Qty. Part No. Qty. Hood H7266 H7267 Lower Control Compartment Panel H7262 H7263 Enclosure, Glass Front (Complete) H7264 H7265 Door Latch Spring H6135 H6135 Log Set (Complete) H7244 H7245 Burner Assembly H7258 H7259 Oriﬁce, Main Burner - Natural Gas...
Page 24 REPLACEMENT PARTS Dexen Valve Assembly SIT Valve Assembly NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE. The manufacturer reserves the right to make changes at any time, without notice, in design, materials, speciﬁcations, prices and also to discontinue colors, styles and products. Consult your local distributor for ﬁreplace code information.

This manual is also suitable for:

Sldvt-40 series Sldvt-35nm Sldvt-35pm Sldvt-40nm Sldvt-40pm Sldvt-35ne ... Show all

Superior SLDVT-35 Series Care And Operation Instructions Manual

Quick Links

Troubleshooting

Need help?

Questions and answers

Related Manuals for Superior SLDVT-35 Series

Summary of Contents for Superior SLDVT-35 Series

This manual is also suitable for:

Table of Contents