Table of Contents
Advertisement
1. Place fiber ramp log in center of chassis
as shown in Figure 24. The fiber ramp log
can be identified by the shape and much
lighter weight when compared to the other
logs. The log must sit flat on the black
sheet metal and behind the left metal tab
as shown in figure 24a. Make sure the side
marked ''BOTTOM'' is setting down.
Ramp Log
Metal
Tab
Figure 24 - Installing Fiber Ramp Log
f i r e - p a r t s . c o m
Metal Tab
Figure 24a - Installing Ramp Log
2. Place front left and front right logs as shown
in Figure 25.
Right Front Log
Left Front
Log
Figure 25 - Installing Left/Right Front Logs
3. Place left ember bed log as shown in
Figure 26. The log has groove on one side
that sets on the ember bed pan. The back
side of this log needs to rest against the
front of the base assembly. Make sure the
flame from the ember pan does not touch
the ember bed log.
126543-01A
INSTALLATION
Continued
Ramp
Log
www.lennoxhearthproducts.com
4. The SVFS32 and SVFS36 use two dif-
ferent right ember bed logs. The SVFS32
right ember bed log is installed in the same
manner as the log in step 3 above but on
the right side. The SVFS36 right ember
bed log has a hole in the bottom that sets
on the grate finger and the other end rest
on the fireplace floor, place log as shown
in Figure 27. The back side of this log
needs to rest against the front of the base
assembly, make sure the flame from the
ember pan does not touch the ember bed
log.
Figure 26 - Installing Left Ember Bed Log
SVFS36 Right
Ember Bed Log
Hole
Underneath
Grate Prong
Figure 27 - Installing Right Ember Bed Log
5. The left middle log has a groove on the
bottom to sit on the chassis and has to sit
on the tab on the back of the left front log
as shown in Figure 28.
Figure 28 - Installing Left Middle Log
Left Ember
Bed Log
Left Middle
Log
17
Advertisement
Table of Contents
