DT SWISS F 535 ONE User Manual page 21

3.4 FITTING THE BRAKE
The fork has a PM 7" brake calliper mount. If the brake calliper is mounted on the fork without an
adapter, a Ø180 mm brake disc can be used. A brake disc up to Ø203 mm can be used with a suitable
adapter. Do not use brake discs with a diameter bigger than 203 mm!
1. Ensure that the thread lengths of the fastening
screws on the brake calliper or brake adapter
are at least 8 mm and no more than 15 mm (see
figure).
2. Fit and adjust the brake according to the
manufacturer's specifications.
3. Check that all components are moving freely.
3.5 FITTING THE BRAKE CABLE HOLDER
1. Click the brake cable into the brake cable holder.
2. Fit the brake cable holder with clicked in brake
cable into the hole in the fork arch.
3. Push the screw through the fork arch and screw
it into the cable holder. Tighten the screw with a
torque of 1 Nm.
4. Ensure that the brake cable does not touch
the fork crown while riding and that it does not
impair the function of other components.
3.6 FITTING THE FENDER
1. Attach the fender to the rear of the fork arch.
2. Insert all four screws and tighten them to a torque of
1.5 Nm.
CAUTION: Do not exceed the specified tightening torque
under any circumstances! This can damage the fork
threads beyond repair.
F 535 ONE - User Manual V2021.08
21