Outer Dimensions Of Outdoor Unit; Diagram Of Outdoor Unit Installation - Argo AWMI28AHL Installation Instructions Manual

Outer Dimensions of
2-3.
660 110
13 13
A
13 13

Diagram of Outdoor Unit Installation

2-4.
Never install only a single indoor unit.
Be sure to connect indoor and outdoor units only in
combinations that are listed in the catalog or in the
combination table that was provided with the outdoor unit.
(Use caution. Connecting any other model may result in
operation failure and malfunction.)
The dimensions indicated by ⇔ in the figure below are
spaces that are required in order to maintain
performance. Install in a location where the dimensions
indicated by ⇔ are ensured, and where 2 or more faces
of the unit are unobstructed. In principle, the top direction
should be unobstructed.
Ensure 150 mm
of space if a
drain hose is to
be used.
Base (not provided)
(concrete or similar material)
Outdoor Unit
A
940
Fig. 5
Cable fastener
Power breaker
A
B
C
D
Inspection panel
Fasten with anchor bolts
(not provided)
(3/8" or M10, 4 locations)
Fig. 6
6
Service valve on narrow tube side
(Outer diameter φ6.35)
Service valve on wide tube side
(Outer diameter φ9.52)
Service valve on wide tube side
(Outer diameter φ12.7)
Service space
Unit: mm
Tubing
panel
Ground
wire
(not
provided)
Indoor unit A
Indoor unit B
Indoor unit C
Indoor unit D